Simply Maya User Community

Simply Maya User Community (https://simplymaya.com/forum/index.php)
-   Maya Modeling (https://simplymaya.com/forum/forumdisplay.php?f=9)
-   -   Break between nurbs surfaces (https://simplymaya.com/forum/showthread.php?t=33685)

Olorin 29-01-2010 11:08 PM

Break between nurbs surfaces
 
1 Attachment(s)
Howdy.

I thought I should give nurbs a little test and I hit a snag at once. I did a few cureves, a birail, then lofted the top to close it off and get a break between them when I render. It does not show up in the viewport when I am editing. What is this and why does it appear?


All times are GMT. The time now is 10:44 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Simply Maya 2018