Apache Tutorial - Part2: Split Polygon tool problem
Hi,
I bought the apache tutorial a while a go, but only recently started working on it. I'm currently on part 2 of the modeling. At about 3 minutes into the video the instructor starts doing a poly split along the top part of the apache. Now when I try the same thing it always fails with the following error: / Warning: Can't perform polySplit1 on selection // polySplit -ch on -s 1 -sma 0 -ep 376 0.5 -ep 375 0.5 -ep 345 0.5 -ep 524 0.5 -ep 209 0.726009 -ep 210 0.5 -ep 211 0.5 -ep 212 0.5 pCylinderShape1 ; So I tried using the polysplit on each individual polygon and I get almost half way around before I get a similar error: // Warning: Can't perform polySplit3 on selection // polySplit -ch on -s 1 -sma 0 -ep 581 1 -ep 10 0.5 pCylinderShape1 ; // Result: polySplit3 // This is about where it stops: http://www.joe-horacki.com/WIP/part2-polycut-test.jpg Does anybody have any ideas/suggestions? |
you have some verts that arnt merged correctly, that are causing what appears to be a solid edge, to in actuality be two edges on top of each other.
That woudl be my guess.. Go into vert mode, select all the verts, and use a merge vertex function with the tolerance down low like .001 or something g-man |
Quote:
|
Try deleting the poly on either side of that edge, then using the append to poly tool to put it back in. Quick easy fix for the issue that doesn't involve 2 or 3 hours of trying to figure out where you went astray.
Save those searches until you have the basics of Modeling well in hand ;) g-man |
Quote:
|
Any time
|
All times are GMT. The time now is 05:33 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Simply Maya 2018