|
Nurbs attach curve major Issue HELP
1 Attachment(s)
I am simply trying to make a perfect oval,
•I first make a nurbs circle, set the sweep to 180, •Then duplicate and rotate, so they mirror one another. •Then I go to attach curves, then in the att. editor I Change the Method: to connect from blend. For some reason no matter what I do one side is always not the same as the other. An i need to be able to run a planar command on the curves it wont work unless the lines are perfect... Please help this is for a school project and Im totally dead in the water. thanks |
Not sure what the problem is exactly, but i know curves are a bit funky with curvedirection so i would check that first, then i would change the connection method back to connect instead of blend.
If this doesn't work i would cut the curve down the middle delete the half you don't like(the rightside i suppose) duplicate and mirror the half you like adjust the curvedirection if needs be and attach it with a simple connect in the middle . Also make sure that keep originals is off good luck :beer: |
| All times are GMT. The time now is 12:01 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Simply Maya 2018