proxy poly extrusion problem
1 Attachment(s)
Hello,
Apologies if this has already been covered - i had a good look through the forum and couldn't see anything concerning this problem. Basically I am extruding a face several times in Polygon Proxy mode to make a finger. By about the third time that I extrude, the subdivision surface suddenly starts to be indented in the middle and by the time that I have finished extruding the finger, the base and the tip are fine, they are smooth and rounded, but the shaft of the finger is smaller and looks like a rectangle polygon with sharp edges. I'm new to Maya, but I don't remember this happening before. You can view images of the problem at: http://pg.photos.yahoo.com/ph/arran_.../ph//my_photos I have tried playing around with 'Keep Faces Together' and rebuilding the model with no success. My smooth Proxy Settings are on default. I have also reset Maya to it's default settings by deleting User Prefs in the Prefs folder. What am I doing wrong? Any help would be appreciated. Thanks. Arran |
Ok. Figured it out. It was just the display settings. As soon as I pressed 3, the problem was solved.
I can't believe how stupid I am. |
just had the same problem with nurbs curves. but I´m using maya for over a year now. so don´t tell me you are stupid!
:) |
Yeah, Maya tends to make you feel like that.
Cheers! |
All times are GMT. The time now is 06:37 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Simply Maya 2018