Maya to Zbrush/Mudbox
After a 5 months layoff, I will be getting up and running again in maya, for those of you who saw my novice work, as before I will be doing another character model, but was thinking of starting it in maya then moving it over into zbrush /mudbox,for experimenting....though I still need to go a long way to even get to the level I have seen from other members.
I just want to know how do I actually import a model over into these over pieces of software. Thnaks in advance :) Jt |
going between maya and zbrush and back you can use the GoZ feature
alternatively you can export your models as obj files you can probably do the obj export for between maya and mudbox and back |
Like Chrirone said and try to have only four sided polys, also check you mesh in zrush under geometry check mesh integrity........dave
|
how do you use the goz feature, and how do I make the file into an obj....I am off an on maya so much I am still in on my starting block, I try keep my hand in but sometimes I have a bit of work to get through with uni?
Thanks again for the response |
If you can open and save a file you can figure this out as it's quite straight forward
GoZ is built into ZBrush since ZBrush 4 came out. The button is in the Tool Palette GoZ ZBrush -> Maya To use it select the tool in ZBrush and click GoZ in the Tool palette. Maya will open with the mesh GoZ Maya -> ZBrush Select the mesh and click the GoZ button on your shelf. The shelf is put there when you install ZB4 assuming you told it to do that. If it's not then you'll have to find the script and put it there obj zbrush -> maya: select the tool and click export in the Tool palette. the default export option is obj in maya select File > Import to import the obj file obj maya -> zbrush/mudbox select the mesh and click File > Export Selection I think when using obj there's something you have to turn off. Select options when you export from maya and turn off everything other than normals. I don't remember what it is you turn off but that was my last setting for it... There might be something special to go between maya and mudbox but i've never used mudbox for more than a few minutes on someone elses computer. But given that they are both autodesk products now there might be something. Like, mudbox could probably open fbx files, which I hear is common between autodesk products |
thanks again for the valuable advice:)
|
Hey man I know this is a maya site but it looks like your very informed about ZBrush too. In ZBrush my models keep losing their symmetry... I start it symettrical and by a couple hours through the piece, it gets distorted! Changing the symettry axis and using the 'posed' symettry tool doesn't work. Any suggestions?
|
All times are GMT. The time now is 01:30 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Simply Maya 2018