Hey, was looking through a Rhino book at school, and they have this tut. on how to make headphones. Anyways, to make the top of the headset, they would tell you to create a curve that is like a half circle, then create 3 curve profiles, 2 on the ends of the curve and 1 on the top, then attach them to the curve and make the curve on the top a little bigger. Then you do this command and it kind of "lofts" the curves but the lofting follows along the curve. It's kind of like extruding with 3 profiles. Then i was like neah... Maya is sooo cool there has to be a way to do that too, but i couldn't figure it out, so does any1 know how to do it??
thanx