Thread: Dog Model
View Single Post
Old 07-12-2010, 02:40 PM   #1
Vox520
Registered User
 
Vox520's Avatar
 
Join Date: Sep 2008
Posts: 3
Thanks: 0
Thanked 1 Time in 1 Post
Default Dog Model

After finishing the tutorial on how to model a dog, I went to convert from polygons to subdiv, yet nothing was happening. I then went back to before I joined the two halves and it worked perfectly. I have adjusted the slider to the maximum value and still nothing. This might mean that there is to much geometry?

I was planning on rigging this model in the future, so if anyone could assist me with this problem it would be appreciated.
Vox520 is offline   Reply With Quote
The Following User Says Thank You to Vox520 For This Useful Post:
navninja1 (25-06-2011)