View Single Post
Old 12-12-2010, 06:30 AM   #2
bullet1968
Lifetime Member
 
bullet1968's Avatar
 
Join Date: Feb 2010
Location: Australia
Posts: 4,255
Thanks: 158
Thanked 651 Times in 621 Posts
Default

I have had the same problem going from ACAD to Maya....I THINK (cant remember) in the newer ACAD you can triangulate a mesh.....I will do a check later for you. I too tried lofting from polylines but got the same result as you did. Will get back to you mate

cheers bullPS if you are trying to loft dont do all of the curves at once either...one at a time I found but it is painful if you have a lot of contours
__________________
bullet1968

"A Darkness at Sethanon", a book I aspire to model some of the charcters and scenes

Last edited by bullet1968 : 12-12-2010 at 06:31 AM. Reason: addenda
bullet1968 is offline   Reply With Quote
The Following User Says Thank You to bullet1968 For This Useful Post: