View Single Post
Old 13-01-2011, 09:53 AM   #3
joni.giuro
Registered User
 
Join Date: Dec 2010
Posts: 16
Thanks: 0
Thanked 4 Times in 4 Posts
Default

if you're working with polys I think you can easily fix that by moving vertex and or extruding edges.
If it's surfaces I would add the little curve at the beginning of the path curve and then project a curve on it from the front view and cut the surface in the desired position.
hope it helps
joni.giuro is offline   Reply With Quote
The Following User Says Thank You to joni.giuro For This Useful Post: