View Single Post
# 3 11-07-2011 , 12:51 AM
Registered User
Join Date: Sep 2007
Posts: 78

Not sure if this is what you're looking for, but you can change the options to be "equal distance from edge" instead of relative distance.

Nope. Perhaps I wasn't clear?


What I mean is: For example - I have 3 extruded edges from a cylinder. I want to do the edge loops around the three extruded polys. Since they all are separated from each other, the edge loop will not go around all three of them. So you'll have to add edge loops individually, thus causing the distance of the edge (of the extruded poly) and the edge loop to be a little different.

If this is not clear, I'll gladly take some screenshots! I'm terrible at trying to explain. user added image