hi,

I occasionally find after trying out different decays etc. that the intensity slider of a light becomes ridiculously impractical - usually after cranking up the slider numerically to 1000 or more; if afterwards I remove the decay and need to go back down to a low intensity value, the slider is still operating on a scale of 0-1000 which means I have virtually no control down in the 0-10 range.

In mudbox you can double click the slider to fit the range of moment to the value you have set (so if you set a numerical value of 3, double-clicking the slider will give you a range of 0-3, and so fine control)

any way in maya 2016 to do this?


thanks



j