HI everyone!

I have run into another delima here that I think is more frustrating becuase I know that everyhting is built correctly (Isoparms etc) but I can't get the surface to attach correctly without getting some crazy surface on drugs. I have to make a "water tight model" meaning everything must be solid.
I can however get the sides to attach properly but it is just the top (white) and the bottom of the peice that wont attach that give the surface thickness. Should I scrap this and extrude the surface instead of offset like it is? Mommmmmmmmy?

Check the pic

I am not giving up, I am slowly getting there


Best - Moff