Thread: Extrude Splits
View Single Post
# 12 01-02-2004 , 02:11 AM
Subscriber
Join Date: Jun 2002
Location: Texas
Posts: 374
Just something i noticed, you need to clean up the faces on the rear part of the model, if you go into face mode you'll see a lot of faces just sitting in the middle of edges, you can delete those, rest of the model looks ok. The other thing i would mention is when modelling, try to keep the model at square angles to the orthographic cameras, if you look in the front view your model is sitting at an angle, it's tough to work this way.