View Single Post
# 2 12-12-2010 , 06:30 AM
bullet1968's Avatar
Lifetime Member
Join Date: Feb 2010
Location: Australia
Posts: 4,255
I have had the same problem going from ACAD to Maya....I THINK (cant remember) in the newer ACAD you can triangulate a mesh.....I will do a check later for you. I too tried lofting from polylines but got the same result as you did. Will get back to you mate

cheers bullPS if you are trying to loft dont do all of the curves at once either...one at a time I found but it is painful if you have a lot of contours


bullet1968

"A Darkness at Sethanon", a book I aspire to model some of the charcters and scenes

Last edited by bullet1968; 12-12-2010 at 06:31 AM. Reason: addenda