View Single Post
# 2 06-08-2003 , 08:32 PM
sjurick's Avatar
Subscriber
Join Date: May 2003
Posts: 136
OK, I've gone a different route. I created a rectangular path using CV Curves and this worked much better extruding along the path. Only problem is that when I select the openings' Isoparms and perform a PLANAR on them, how do I attach the PLANAR surfaces so that when I move or scale the "ramp" or "step", the PLANAR pieces don't head off in different directions?

Attached Images

"Please excuse the crudity of this model, I didn’t have time to build it to scale or to paint it"
:: Dr. Emmett Brown