View Single Post
# 16 04-02-2004 , 07:58 PM
Registered User
Join Date: Jan 2004
Location: Rochester,NY
Posts: 69
to get the lines you want and an even distribution, it would probably be a good idea to create a line then extrude the face along the line. It is on of the possible extrude settings.

There is then a divisions section in the channel box, when you go there and increase the divisions you will began to see the mesh form a long the curve.

I do think it is a good start, but I also think Morning is correct when telling you to start of with references because they help build a foundation for other ideas and designs.

Good Job, and best of luck.


Improve