View Single Post
# 9 19-01-2006 , 02:04 PM
Tim_LIVID's Avatar
Subscriber
Join Date: Sep 2003
Location: Harwich, UK
Posts: 1,195
I have found another method which I think might be the one for me. Slightly different to Mikes but along the same lines. I thought I would post it here just incase there is some poor guy searching the forums.

You basicaly make a four leaf clover shape, use curve snap and put it on the start of the curve and then rotate it so it is looking down the curve ready to extrude.

Goto Surfaces -> extrude optionbox and click the circle buttons for the first 4 lines all on the right side then extrude.

Click the geomerty you have created and open the channel box, click on extrude1 then type 600 and you get the picture below.

It's light on the geo and should be that hard to move around and make the shape you want.

Attached Thumbnails

"You can live for yourself today -- or help build tomorrow for everyone" _LIVID

Optical Minefield
My Blog