That ELS polytool script came in handy quite a bit in the end

Thoroughly enjoyed the tutorial... learned a few bits and pieces.

My only gripe is the video quality. Resolution is fine but framerate could be better. In fact there were times when it couldn't keep up with the speed of your mouse Jay, so it was a case of trying to figure out what exactly you did cause the video wasn't quick enough to show it. The view port tumbling is also quite choppy because of this.

Also on part 15, around the 34min mark, an entire chunk is missing regarding the shaping of the eye sight. It went from extruding the thickness to having the entire piece finished in a split second. By this point I was able to figure out how to get it looking right - one bit I found tricky was shaping the circular cut out properly.... I found that using a Nurbs circle as a guide and moving those verts while in smooth did the trick.

Not a big deal to be honest...just saying. Anyways... good stuff. Looking forward to more of your work.

regards

-P