Originally posted by gster123
it looks like youve still got a bit of stretching on the main body on the extruded bits, it probably wont matter unless your going to make a rusted look to it.
I probably would planar map the whole extrude then select the UV's then scale them up to match.
Thanks for the advice. I fixed a couple of the spots, but I’m not too worried about them. I’ll just have to be careful with the brush around those areas .
After the last 2 days I’ve spent about 2 hours on it, messing around with the UVs.
Here’s the pic of everything:
Last edited by Jr.Who; 24-09-2007 at 10:43 PM.