View Single Post
# 15 14-10-2007 , 08:57 AM
ctbram's Avatar
Moderator
Join Date: Jan 2004
Location: Michigan, USA
Posts: 2,998
I textured the sides I plan to planar map. I have attached screen grabs. Is this a good plan?

For the most part I am only concerned with the seem between the front and side (red/cyan) and the front and botton(red/yellow) and the side and bottom (cyan/yellow) only up to the first corner.

On the side and top extruded bits (I have indicated) I am going to get an unacceptable amount of stretching. How do I deal with those areas?

Attached Thumbnails

Last edited by ctbram; 14-10-2007 at 09:01 AM.