Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I just applied a photograph of the surface of a table using the default settings.
I am a beginner and I have never tried fresnel reflections or the dielectric material, but thank you for your help because at least now I can make a nice glass even if not perfect.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off