Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 27-06-2004 , 06:36 PM
Subscriber
Join Date: Feb 2004
Posts: 38

Dodge Viper

Hello everyone

I decided to start a new model this morning. I finally (after looking forever) found some nice blueprints. (https://www.suurland.com/ <<< great blueprint site) I found blueprints for a dodge viper (one of my favorite cars). I recently posted and thread on box modeling and mtmckinley helped me to understand that more. I wanted to try that out but the more I looked at the viper I decided that box modeling probably wasn't the way to go. Mainly because the viper is all smooth curves, there are almost no hard edges etc. My problem is I have never modeled by patch modeling ( i think that is what I am doing) I have attached an image to show you what I am doing. I just need some advice and where to go next. I have drawn a profile curve but I don't know where to go now. please help.

P.S. sorry about the image size, I tried to make it as small as possible.

Attached Thumbnails
# 2 27-06-2004 , 08:01 PM
NextDesign's Avatar
Technical Director
Join Date: Feb 2004
Posts: 2,988
I would say that you should check out this tutorial on patch modeling.


Imagination is more important than knowledge.
# 3 28-06-2004 , 01:27 AM
vladimirjp's Avatar
Subscriber
Join Date: Jun 2003
Location: stuck in the 90's boston, USA
Posts: 1,871
https://alliedplayaz.com/alliedplayaz/gt3/initial.html

a good tut on modeling a car with (the Porshe)NURBS.
modeling a car in NURBS is not patch modeling.

this is an intermediate tut, but for the most part he tries to explain things as clearly as he can.
as for the no hard edges on the viper, box modeling can give as good as result
assuming you have good poly modeling skills.
besides nurbs modeling is much more involved and time consuming than poly modeling.

# 4 30-06-2004 , 12:16 AM
Subscriber
Join Date: May 2004
Posts: 21
I can't see the third page on the GT3 tutorial :/

# 5 02-07-2004 , 07:08 PM
Registered User
Join Date: Jan 2003
Posts: 65

Originally posted by vladimirjp
https://alliedplayaz.com/alliedplayaz/gt3/initial.html

a good tut on modeling a car with (the Porshe)NURBS.
modeling a car in NURBS is not patch modeling.

Hi,

The term "patch modeling" means Nurbs to me. You deal in 4 sided Nurbs patches. I don't know what else it could refer to.

sj

Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads