Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Just reserving a seat here. I have an idea for the entry and even a couple of quick sketches too. Not sure if I'm going to finish this in time though....
It's a boot camp where reindeers are learning to fly
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is Off |
HTML code is Off