Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I'm doing the Spitfire tutorial and I'm at a point where I seperated the wing from the body by deleting faces. The geometry is still whole. Now I check Sub-D to make sure model alligns to the image plane. But the change to Sub-D causes delete.
delete |polySurface2|polySurfaceShape6;
I went back to before I deleted the faces and it changes to Sub-D but the verticies are unselectable.
I don't know if the problem is what I'm doing in the model or is something screwed up in my settings.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off