Introduction to Maya - Modeling Fundamentals Vol 2
This course will look in the fundamentals of modeling in Maya with an emphasis on creating good topology. It's aimed at people that have some modeling experience in Maya but are having trouble with complex objects.
# 1 31-01-2004 , 01:49 AM
maya4todd's Avatar
Subscriber
Join Date: Jan 2003
Location: Santa Monica, CA.
Posts: 163

NURBS cylinder - adding thickness

I want to create a NURBS cylinder and add thickness to it's sides.

Hows by I do that? :bgreen:

# 2 31-01-2004 , 02:48 AM
NightPhantom's Avatar
Registered User
Join Date: Nov 2003
Location: Florida
Posts: 269
create a smaller cylinder and place it inside the first one. Obviously you would only be able to see the thickness if the cylinder is open (or if it's semi-transparent, in that case you can disregard the following). So, if say for example that you cylinder doesn't have the top, you would be able to see both cylinders and the space in between them; to make that look like it's one solid pipe just create a curve conecting both cylinders and birail a ner survace between the cylinders.


There can not be Good without Evil, so then it must be good to be Evil sometimes.

:tup:
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads