Camera Manipulation Handles

Maya for 3D Printing - Rapid Prototyping

In this course we're going to look at something a little different, creating technically accurate 3D printed parts.

Watch

# 1 28-10-2003 , 05:21 PM

Subscriber
Join Date: Apr 2002

Location: The Planet Apple MacTosh

Posts: 523

OK, I create a camera then hit the 'T' key to get the manipulation thingy. The first click shows the point of interest, the second shoes the pivot point and by clicking in the cycle to highlight it it makes it active. But I cannot figure out what the third is or how to control it since it disappears into the far clipping plane.

Is it angle of view and focal length? Mind you they are related so its one and the same thing...

Tickety boo and ta ta for a bit...
Gazzamataz
https://www.gazzamataz.com

Quote

# 2 28-10-2003 , 08:01 PM

Moderator
Join Date: Sep 2002

Location: London, UK

Posts: 3,198

It is for controlling the near and far clipping planes. By default they are at 0 and 1000 so it's pretty difficult to move them using the manipulation tool. Enter something like 5 and 20 in the attribute editor and you should see them better.

Kari
- My Website
- My IMDB

Do a lot, Fail a lot and Learn a lot!

Quote

Reply to this thread