Maya for 3D Printing - Rapid Prototyping
In this course we're going to look at something a little different, creating technically accurate 3D printed parts.
# 1 02-04-2003 , 08:37 PM
killerBee's Avatar
Subscriber
Join Date: Nov 2002
Location: ireland\galway
Posts: 102

April Challenge - KillerBee - Noobie"

well i will try it again the challenge ..here is what i am thinking about ,,but i cant model heads for S**T but it all about trying ..i did this quick but you get the ID ..


P4 3.2 ATI 9800xt 256. 1gb ram 19"lcd ..
# 2 05-04-2003 , 11:43 PM
killerBee's Avatar
Subscriber
Join Date: Nov 2002
Location: ireland\galway
Posts: 102
ok i made a start on it


P4 3.2 ATI 9800xt 256. 1gb ram 19"lcd ..
# 3 06-04-2003 , 02:46 AM
mumbojumbo_13's Avatar
Subscriber
Join Date: Oct 2002
Location: The Land Down Under
Posts: 1,047
could you add a few lights around it's a bit hard to see but apart from that nice start


Thanks for wasting your time reading this line.
# 4 06-04-2003 , 04:30 AM
tariqrf's Avatar
Subscriber
Join Date: Jul 2002
Posts: 1,253
yep... add a three point light setup

# 5 23-04-2003 , 08:23 PM
killerBee's Avatar
Subscriber
Join Date: Nov 2002
Location: ireland\galway
Posts: 102
all SM team i been not around a lot for this challenge as
allso no time with maya so i must pull out of the April challenge
sorry about that just i have not the time as of late .. but i hope to be back for the next one ..thx all good luck to all on the APRIL CHALLENGE ..


P4 3.2 ATI 9800xt 256. 1gb ram 19"lcd ..
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is Off | HTML code is Off

Similar Threads