Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
i am building a laptop, and i was woundering if windows media will still run maya? or should i stick with xp? and will maya be compatible windows vista? o and is hp a good laptop to go with?
Dunno about the windows media, I run Maya on XP home and it's fine.
How do you go about building a laptop? I thought they were pretty much standard from the manufacturer as the parts are soldered in to stop them ratteling and messing up?
The one thing that you might need to look into is the graphics card if your running maya on it.
Depending on what your after you can get the same spec laptop (from the same factory) cheaper if you have a shop around, the thing is you dont get the funky paint job but you could save a few hundered if your lucky.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off