Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Use the batch render to render the animation out as an image squence. Make sure in the render globals it says "name.#.ext". Then use this free little piece of software to compile them https://www.gromada.com/videomach.html
EDT: - or just do what Dann said. I must type far too slow.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off