Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Print Screen is always accessible, as it's built-in, ... by the way, I prefer advising you these 2 tools.
SNAG IT : capture (screen, window, active window, region, fixed region to any type of output: file, mail, clipboard, print) CAMTASIA : capture too, but the movie way. Ideal to create presentation and tuts.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off