Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
The IK spline comes with one. a curve should have bean created with your IK spline. Look for it in the outliner, Select it. press F8 for componet mode and move the CV's around. you'll notice the joints falow that curve. You can rebild the curve if you like also.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off