Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 28-07-2008 , 04:50 AM
Registered User
Join Date: Dec 2007
Posts: 124

Spring Compression Animation ...

What is the correct procedure for animating a spring compressing. I've tried the squash deformer but my geometry doesn't want to cooperate. The surfaces are separating, in spite of being grouped.

# 2 29-07-2008 , 02:30 AM
bendingiscool's Avatar
Subscriber
Join Date: Jul 2006
Location: London
Posts: 567
I don't think this is your direct problem but it may help, you could have a couple of different sized springs and use blendshapes to go between the stretched out one and the compressed one.

Chris

# 3 04-08-2008 , 02:36 PM
NeoStrider's Avatar
Registered User
Join Date: Jun 2004
Location: Cleveland, Ohio (USA)
Posts: 1,541
use a lattice deformer on the curve you're creating your spring with, (i'm assuming you extruded a circle along a CV or EP curve)not on the finished spring itself. that way the roundness of the spring won't also deform.


Accept no substitutions.
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads