Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Cant really see your channel box to read what it says, but to me it seems that what you're looking for is to make an "IK Spline Handle", a lot of us riggers use that instead of FK joints for a back, mainly for cartoony characters of course!
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off