Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 09-01-2016 , 07:11 PM
Registered User
Join Date: Jan 2016
Posts: 5

Why After I Smooth Bind Mesh It Will Double Translate?

Why after when I smooth bind my joint rig to mesh, it suddenly will make my mesh double translate when I am rotating my contorller and joints?

Before I smooth bind it was working prefectly.

Is there any possibllity that I can fix this?


Last edited by computertech; 09-01-2016 at 07:20 PM.
# 2 09-01-2016 , 11:49 PM
Registered User
Join Date: Jan 2016
Posts: 5
Nevermind, I fixed it. I just learned that I need to separate my smooth binded mesh and my joints in Hypergraph Hierarchy to stop my double translation.

Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads