Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Can you show us the profile and rail curves?. It looks like you have two rail curves passing close together at that point creating a pinch. If that is the case then just seperate them a bit.... Thats just a guess without really seeing them though....
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off