Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
i've been away from my computer for a while (actually quite a good thing to do)
But now I'm back with questions
when modeling I usually convert from polys to subd's. This goes back and forth a couple of times to add extra geometry in poly mode and so on.
Last time I converted back from subdiv's to polys added some geometry and then back to subdiv's. After I did that I noticed that some changes I made earlier had disappeared. Just subtleties, but still anoying.
The geometry I added was in a completely different part of my model then were my details disappeared, so I think that cannot be the reason.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off