ToothBrush.

# 1 01-03-2006 , 06:55 PM

Subscriber
Join Date: Oct 2005

Location: Leeds

Posts: 1,154

Hey folks, ok maybe pretty simple but im not sure how to go about make the bristles for a toothbrush, any suggestions would be appreciated user added image

Thanks.
Sy

Quote

# 2 01-03-2006 , 07:09 PM

Moderator
Join Date: May 2005

Location: Manchester Uk

Posts: 6,300

What about fur or hair? Group it tightly together in circle shapes then duplicate and move into position?

Or use a Cylinder and texture map it if the details are not too important?

Quote

# 3 01-03-2006 , 07:35 PM

Subscriber
Join Date: Oct 2005

Location: Leeds

Posts: 1,154

never used hair yet,! ill give that way a go. Thanks. i wanted it to be high detail, so just texturing wouldnt b good enough.

Quote

# 4 01-03-2006 , 11:31 PM

Registered User
Join Date: Apr 2005

Location: Fairfield, CT

Posts: 2,436

lots of little modeleld cylinders, each modified a tiny bit... mayb about 6 or 7 variations, and then you group them how u want

Live the life you love, love the life you live

Quote

# 5 02-03-2006 , 10:09 AM

Registered User
Join Date: Dec 2005

Posts: 187

use PFX dude, i wos suprised with the results but if u check out my jelly fish PFX are suprisingly good, + u can alter every detail or them, you could make it quite dense with no curves or bends, or maby just a little if u wont it to look a bit used? Like the ends bend up due to brushing too hard? If you go onto my thread, in the W.I.P section about jellyfish there is a post on the first page about a tutorial follow that to make tenticles and then just do a lot of tweaking until you get what you need.

Quote