Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
When i make lets say a Spot Light.. it just make one Cone.... But not the other cone it normaly did in 6.0, i mean the Light Direction Cone... One Cone light, and Other Cone Light Direction...
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off