Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
never mind, turns out some of the verts were criss crossed (when I zoomed in) even after I merge verts so I centered them one by one and select and sew the edges one by one and it works fine.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off