painting weight frustration

Maya 2020 fundamentals - modelling the real world

Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.

Watch

# 1 20-11-2004 , 07:23 PM

Subscriber
Join Date: May 2004

Posts: 233

I have finaly completed the rigging of my model and need to paint the weight.

Everything is simple except that when I try to paint and area, for exemple fingers, I sometime paint by accident another, ex: torso, and dont notice it until I do some testing by moving the squeleton.

This is very frustrating because I have to fix it and while doing so I also happen to paint on another area and the problem repeat itself over and over...

So is there a way to make sure that once I paint weight, it will never change?

Or to prevent Maya to add weight to area that are not directly connected to the one I am working on?

Thanks!

Quote

# 2 20-11-2004 , 07:43 PM

Subscriber
Join Date: Jun 2003

Location: stuck in the 90's boston, USA

Posts: 1,871

toggle hold weights to on. .

or if u are doing smooth skinning, use the "bind selected joint" method, and choose only joints the may accfect your skin.
[ie. for fingers, all finger joints and wrist joint or possibly a forearm joint- may affect your hand skin. u can then mirror the weights across on the other hand.]

for the mirror to work properly, you may need to bind both hands at the same time to their corresponding joints.
this method is a little tricky, because of how maya displays selected joints.
otherwise use the hold weights options to make life easier.

Image dump

Quote

Reply to this thread