Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Yes you can select an region of polygons and smooth them seperately. However smoothing is not a modelling tool designed so much as to sculpt a solution, but more to refine an allready sculpted form.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off