Help me please, attatching tool.
I have tried Everything!!! yet it the two nurbs surfaces will NOT attatch, with either of the two surface attatchment tools for nurbs.
I have fiddled with it in any way thinkable.
-I did a Boundry ops, on 4 rebuild curves (20spans each).
-All four curves are in contact with each other.
The surface looks ok, but I have no idea what could be the problem.
well, it makes an attatchment with the "ordinary" attatchment tool, BUT if it ever attatched the two surfaces together, it did it at the wrong place.
It it supposed to attatch at the top and/or bottom and NOT in the "center".
I get the same result even If I use the "attatch surface without moving".
Last edited by undseth : 11-01-2003 at 11:18 PM.