Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Yes, there are some 5 sided polys on the forks near the middle prongs but that was on purpose. It works best like this when smoothed, which turns it into 4 sided polys with great flow.
Don't be satisfied with what you can do but rather strive to do the things you can't do!
Exceed Expectations!
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off