ToothBrush.
Hey folks, ok maybe pretty simple but im not sure how to go about make the bristles for a toothbrush, any suggestions would be appreciated :D
Thanks. Sy |
What about fur or hair? Group it tightly together in circle shapes then duplicate and move into position?
Or use a Cylinder and texture map it if the details are not too important? |
never used hair yet,! ill give that way a go. Thanks. i wanted it to be high detail, so just texturing wouldnt b good enough.
|
lots of little modeleld cylinders, each modified a tiny bit... mayb about 6 or 7 variations, and then you group them how u want
|
use PFX dude, i wos suprised with the results but if u check out my jelly fish PFX are suprisingly good, + u can alter every detail or them, you could make it quite dense with no curves or bends, or maby just a little if u wont it to look a bit used? Like the ends bend up due to brushing too hard? If you go onto my thread, in the W.I.P section about jellyfish there is a post on the first page about a tutorial follow that to make tenticles and then just do a lot of tweaking until you get what you need.
|
cheers guys.
ill take a look Jhubbard, ty :D |
All times are GMT. The time now is 01:31 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Simply Maya 2018