automatic mapping
 

hi i get this message when i ayutomatic map a piece of geometry> // Error: This command requires at least 1 argument(s) to be specified or selected; found 0. //
i was told by someone on a forum to take the geometry out of the group. i did that but i still get the same message.

It says that when you don't have an object selected... If that's not the case, please explain the situation better.

Can you post a pic?

automatic mapping probs
 

hi, I have posted a pic with this thread. its just a piece of geometry with the message i get when itry to map

Hmm, that's really odd…… why don't you just duplicate and move another one of those pillars over and use that?

auatomatic mapping probs
 

tried it. all the pillars and even other bits of geom. are the same. i c get the same error message for all? any other idead will be appreciated