Having some probs
 

http://members.optushome.com.au/hardwired/nurbsProb.jpg

Here's the story, the hat for my little robot was 2 seperate nurbs pieces, 1 for the brim and 1 for the top bit, so i converted to subd's then to poly's combined em then merged verts to make it one piece, converted back to subd's then back to nurbs and rebuilt the surface. The problem is there are many cv's in the circled area and not just 1. Which i believe is causing the dark grey dot.

http://members.optushome.com.au/hard...nurbsProb2.jpg

Tips, pointers, suggestions, detailed explanations on how to fix, all welcome :D

noone have any ideas?

I think I can help...

try to combine all the vertecies in the middle to one single virtex

-Emo

if you make sure that the 2 closest hulls are perfectly tangent that should go away