Smooth doesn't Work?
1 Attachment(s)
Well I've made most of my model... and then I realize that it looks a little rough or square. I tried to smooth it but it did not work, made no difference.
Here is a pic of it. Any suggestions to smooth it out... that would be greatly appreciated. |
Well, it depends on how you've made it. For something like that, I'd go with a NURBS cylinder and make some smaller cylinders going through the main one where the holes should be, and cut them using Intersect Surfaces (or fillet if you need a rounded edge) and trim the surfaces.
Smoothing polys or sub-d's is too complicated with stuff like this imo, because you have to have as many quads as possible... |
All times are GMT. The time now is 08:18 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Simply Maya 2018