Wierd Extrude Edges
 

I am having a problem when building a car that when i try to extrude the edges anywhere on the front of the car including doors it seems to set the pivot someplace stupid instead of along the first where if i do the same thing on the back it sets the pivo correctly and orrentates it as well, why wont it do this on the front

Here an image of the front

Pivot marked in red
Extruded edge marked in yellow

Here is what I want to happen but this only happens on the rear of the car

hit insert and check if the pivot is locked.

ok I have it sorted I had to model the whole thing again but at least it is sorted must have been something I did first time round that screwed it up

Thanks
Rob