Using curves to create 3D
1 Attachment(s)
Hi,
I am trying to make a logo 3D. I have put an image of it on the image plane and traced the edges with the EP curve tool. How do I now make it 3D?? i.e. Add surfaces to it? Thanks, Very Stuck! |
lots of options
1) duplicate and move up to desired height and loft between each set of 2 cures 2)use bevel plus tool and tweak with the settings |
Thanks
1 Attachment(s)
Hi,
Thanks for your reply. The loft worked but now I need to somehow create a surface. See attached Images. Thanks. Trying to get this- |
1 Attachment(s)
From this:-
(minus the writing) |
ERMM CANT REMEM OFF THE TOP OF MY HEAD
select the outside curve then all the urves inside - the do a planar operation (surfaces -> planar) then do same for the bottom now u should have a top and ottom in 2 operations good luck |
All times are GMT. The time now is 05:13 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Simply Maya 2018