Removing UV layout?
I did a UV layout of my sea creature and went to attempt painting and realized just how SLOPPY my layout was. So after weeks of contemplating I finally decided I should redo the UV's and spend some actual time on laying them out.
My question is, can I remove the previous UV's that I have sitting in my UV editor? Or am I pretty much stuck with these UV's? I hope I can redo them. |
nevermind, didn't notice that under Polygons in the UV interface that there was a "Delete UV's" option
|
you could also just planar/etc map them again, you don't have to delete them.
|
thanks for that info, I'm just going with a fresh start though. I'll keep that in mind when I lay out uv's on another project and rush through them the first time and have to go back and redo them, haha.
|
I had to necro this tread just to thank you. So simple to delete them, yet I checked everywhere else but in the first menu.
|
All times are GMT. The time now is 08:20 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Simply Maya 2018